Show Interfaces - Siemens SCALANCE W770 Series Configuration Manuals

Parameter
vlan
vlan-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
If you do not select any parameters from the parameter list, the status and configuration of all
available interfaces will be displayed.
Result
The status and the configuration of the selected interfaces are displayed.
4.1.1.7 show interfaces ... counters
Description
This command shows the counters of one, several or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:

show interfaces

id(1-4094)>}]counters
The parameters have the following meaning:
Parameter
interface-type
interface-id
vlan
vlan-id
For information on identifiers of addresses and interfaces, refer to the section "Interface
identifiers and addresses (Page 29)".
If you do not select any parameter from the parameter list, the entries are displayed for all
available counters.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Keyword for a VLAN connection
Number of the addressed VLAN
[{<interface-type><interface-id>]|{vlan<vlan-
Description
Type or speed of the interface
Module no. and port no. of the interface
Keyword for a VLAN connection
Number of the addressed VLAN
Configuration
4.1 System
Range of values / note
-
1 ... 4094
Range of values / note
Enter a valid interface.
-
1 ... 4094
53