Abbreviated Notation Of Commands; Reusing The Last Used Commands; The "Show" Commands - Siemens SCALANCE W770 Series Configuration Manuals

Description
2.7 General CLI commands
2.7.5.4

Abbreviated notation of commands

Description
The command interpreter of the Command Line Interface also detects commands if only the
first character of the command or its parts is entered.
This is only possible if all the parts of the abbreviated input can be assigned to exactly one
command or to the parts of the command.
Example
The show event config command can be replaced by the expression sh e c.
2.7.5.5

Reusing the last used commands

Description
The Command Line Interface saves the last 14 commands used in a list assigned to the
particular mode. This can then only be called up in the relevant mode.
Example:
In the Global Configuration mode, all entered commands are saved. If you entered commands
earlier in the Interface Configuration mode, these commands are not included in the list of the
Global Configuration mode. You can only call up and reuse these commands in the Interface
Configuration mode.
Procedure
You can page through the list of the commands most recently used using the arrow up and
arrow down keys.
If the command you are looking for is displayed, you can edit the command line as required
and execute the command with the enter key.
Further notes
You display the list of commands last used with the show history command. This function
is available in every mode.
See also
show history (Page 43)
2.7.5.6

The "show" commands

This section describes commands with which you display various settings.
42
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08