No Ipv6 Dhcp Client Request - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols
8.4 DHCPv6 client (IPv6)
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 dhcp client request {dns-server-address | domain-name | sntp-
server-address | option <code (1-100)>}
The parameters have the following meaning:
Parameter
dns-server-
address
domain-name
sntp-server-
address
option
code
Result
The setting is configured.
Further notes
You remove the request with the no ipv6 dhcp client request command.
8.4.3.2

no ipv6 dhcp client request

Description
With this command, you remove the request for the configuration parameter.
Requirement
● DHCPv6 Is activated.
● IPv6 is activated
386
Description
IPv6 address of the DNS server
Domain name
IPv6 address of the SNTP server
Keyword for the option code
Number of the DHCPV6 option
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
-
-
-
-
Enter the required number.
1 ... 200
Configuration Manual, 09/2017, C79000-G8976-C324-08