Siemens SCALANCE W770 Series Configuration Manuals page 30

Description
2.6 Interface identifiers and addresses
Available physical interfaces
Device
W774-1 RJ-45
W734-1 RJ-45
Available logical interfaces
● VLAN
The device supports up to 24 virtual networks.
To be able to use a VLAN, create it with the vlan command.
● VAP / WDS
The WLAN interface supports up to 4 virtual access points (VAP) and up to 4 WDS interfaces
Identification of the interfaces in the command prompt of the Interface Configuration mode
To configure the interface use the command interface in the global configuration mode.
Since you configure precisely one of the existing interfaces in the Interface Configuration mode,
the command prompt shows not only the mode but also the identifier of this interface.
The command prompt is as follows:
cli(config-if-$$$)#
The placeholder $$$ is replaced by the following name of the interface:
Type of interface
wlan 0/X
vapX 0/Y
wdsX 0/Y
fa 0/X
vlan$
The placeholders X, Y, $ stand for the numbering of the interface.
30
Interfaces
2 x Fast Ethernet fa: fast-ethernet
1 x WLAN
Device interface-type
W734-1 RJ-45
vap
W774-1 RJ-45
vap
wds
interface-type
wlan
interface-id
X = 1
Y = 1 ... 4
X = 1
Y = 1 ... 4
X = 1
Y = 1 ... 4
Command prompt
cli(config-if-wlan-0-X)#
cli(config-if-vapX-0-Y)#
cli(config-if-wdsX-0-Y)#
cli(config-if-Fa-0-X)#
cli(config-if-vlan-$)#
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
interface-id
X = 2
fa 0/X
X = 1
wlan 0/X
vapX 0/Y
vapX 0/Y
wdsX 0/Y