Table of Contents
Advertisement
7.1.5.53
wlan hw-retries
Description
With this command, you specify the number of retries. The hardware repetition is performed
by the WLAN chip itself when it tries to repeat an unacknowledged packet immediately.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call up the command with the following parameters:
wlan hw-retries <1-60>
The parameter has the following meaning:
Parameters
1-60
Result
The number of retries is specified.
Further notes
You display the setting with the show wlan advanced <wlan 0/X> command.
7.1.5.54
wlan max tx-power
Description
With this command, you specify the transmit power of the SCALANCE W700 device. It may
be necessary to reduce the transmit power when using antennas to avoid exceeding the
maximum legal transmit power. Reducing the transmit power effectively reduces cell size.
Note
The maximum possible transmit power varies depending on the channel and data rate. For
more detailed information on transmit power, refer to the documentation "Characteristics radio
interface".
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Number of retries
Range of values / note
1 ... 60
Default: 16
Network structures
7.1 WLAN
255
Hide quick links:
Advertisement
Table of Contents
