Spanning-Tree L2T-Auto-Edge; No Spanning-Tree L2T-Auto-Edge - Siemens SCALANCE W770 Series Configuration Manuals

7.3.3.5

spanning-tree l2t-auto-edge

Description
This command specifies that at all layer 2 tunnel ports it should be automatically detected
whether or not an end device is connected.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
spanning-tree l2t-auto-edge
Result
The automatic detection is enabled.
Further notes
You disable the automatic detection with the no spanning-tree l2t-auto-edge
command.
You can display the status of this function with the show spanning-tree l2t-
edgecommand.
7.3.3.6

no spanning-tree l2t-auto-edge

Description
With this command, you disable automatic detection of an end device at layer 2 tunnel ports.
Requirement
You are in the Global Configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network structures
7.3 Spanning Tree
313