Spanning-Tree Bpdu-Transmit; Spanning-Tree Mst - Siemens SCALANCE W770 Series Configuration Manuals

Network structures
7.3 Spanning Tree
7.3.4.7

spanning-tree bpdu-transmit

Description
With this command, you enable or disable the BPDU transmit status at the port.
Requirement
You are in the Interface Configuration mode.
The command prompt is as follows:
cli(config-if-$$$)#
Syntax
Call up the command with the following parameters:
spanning-tree bpdu-transmit{enabled|disabled}
The parameters have the following meaning:
Parameter
enabled
disabled
Result
The BPDU transmit status has switched over.
Further notes
You can display the status of this function and other information with the show spanning-
tree interface command with the detail option.
7.3.4.8

spanning-tree mst

Description
With this command, you configure the various properties of the Multiple Spanning Tree
function:
● With the cost option, you configure the port costs used to calculate the lowest-cost path.
● With the port-priority option, you configure the priority of the interface for negotiating
a Multiple Spanning Tree configuration.
● With the disable option, you disable the interface for the Multiple Spanning Tree function.
330
Description
BPDU packets are transmitted at the
port
BPDU packets are not transmitted at
the port
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
Default: enabled
-
Configuration Manual, 09/2017, C79000-G8976-C324-08