Ipv6 Path Mtu - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols
8.2 IPv6 protocol
The parameter has the following meaning:
Parameter Description
IPv6 address of the neighbor node
prefix
Keyword for a VLAN connection
vlan
Number of the addressed VLAN
vlan-id
Type or speed of the interface
interface-
type
Module no. and port no. of the interface
interface-id
Link layer address (MAC address) of the neighbor node
MAC ADDRESS
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
Result
The entry is deleted.
Further notes
You configure an entry with the no ipv6 neighbor command.
You display the IPv6 neighbor table with the show ipv6 neighbors command.
8.2.3.3

ipv6 path mtu

Description
With this command, you configure maximum packet size (MTU). The setting is only effective
if PMTU Discovery is enabled.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
ipv6 path mtu <prefix addr> <mtu>
364
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Range of values / note
Enter a valid IPv6 address.
-
1 ... 4094
Enter a valid interface.
xx:xx:xx:xx:xx:xx