Ipv6 Address - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols
8.2 IPv6 protocol
Commands relating to other topics that can be called in the interface configuration mode can
be found in the relevant sections.
● If you exit the Interface configuration mode with the exit command, you return to the Global
configuration mode.
● If you exit the Interface configuration mode with the end command, you return to the
Privileged EXEC mode.
8.2.4.1

ipv6 address

Description
With these commands, you assign an IPv6 address to the IPv6 interface.
Requirement
● IPv6 is activated
● The interface is an IP interface.
● You are in the Interface configuration mode
The command prompt is as follows:
cli(config-if-$$)#
Syntax
Call up the command with the following parameters:
ipv6 address <prefix> <prefix-length> [{unicast | eui64}
or
ipv6 address <prefix/prefix-length> [{unicast | eui-64| link-local}]
The parameters have the following meaning:
Parameter
prefix
prefix-length
unicast
eui-64
link-local
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
370
Description
IPv6 address
Number of bits belonging to the prefix
(from left to right)
Addressing mode unicast
Interface ID according to the EUI-64
method
Link local address
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
Enter a valid IPv6 address
1 ... 128 bits
-
-
-
Configuration Manual, 09/2017, C79000-G8976-C324-08