Commands In The Vlan Configuration Mode; Name - Siemens SCALANCE W770 Series Configuration Manuals

You can display the status of this function and other information with the show vlan port
config command.
7.2.4

Commands in the VLAN configuration mode

This section describes commands that you can call up in the VLAN Configuration mode.
In the Global Configuration mode, enter the vlan $$$ command to change to this mode.
When doing this, you need to replace the $$$ placeholders with the relevant VLAN ID.
Commands relating to other topics that can be called in the VLAN Configuration mode can be
found in the relevant sections.
● If you exit the VLAN Configuration mode with the exit command, you return to the Global
Configuration mode.
● If you exit the VLAN Configuration mode with the end command, you return to the Privileged
EXEC mode.
7.2.4.1

name

Description
With this command, you assign a name to the VLAN.
Requirement
You are in the VLAN Configuration mode.
The command prompt is as follows:
cli(config-vlan-$$$)#
Syntax
Call up the command with the following parameters:
name <vlan-name>
The parameter has the following meaning:
Parameter
vlan-name
Result
The VLAN is assigned a name.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Name that will be assigned to the VLAN max. 32 characters
Network structures
7.2 VLAN
Range of values / note
297