Smtp-Server - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols
8.7 SMTP client
8.7.2.1

smtp-server

Description
With this command, you configure an entry for an SMTP server.
Requirement
You are in the EVENTS configuration mode.
The command prompt is as follows:
cli(config-events)#
Syntax
Call up the command with the following parameters:
smtp-server { ipv4 <ucast_addr> | fqdn-name <FQDN> | ipv6
<ip6_addr> } <receiver mail-address>
The parameters have the following meaning:
Parameter
ipv4
ucast_addr
fqdn-name
FQDN
ipv6
ip6_addr
receiver mail-
address
For information on addresses and interfaces, refer to the section "Addresses and interface
names (Page 29)".
Result
An entry for the SMTP server is configured.
Further notes
You delete an SMTP server entry with the no smtp-server command.
You store trhe domain name with the ip domain name or domain name command.
438
Description
Keyword for an IPv4 address
IPv4 address of the SMTP server
Keyword for a domain name
Domain name (Fully Qualified Domain
Name)
Keyword for an IPv6 address
IPv6 address of the SMTP server
Name of the recipient
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Note on the range if values
-
Enter a valid IPv4 unicast address.
-
Maximum of 100 characters
If you have stored a suitable do‐
main name, you can specify a host
name.
-
Enter a valid IPv6 address.
Maximum of 100 characters
Configuration Manual, 09/2017, C79000-G8976-C324-08