Wlan Data Rate-11N Defaults (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

You configure the data transmission speeds with the wlan data rate-11abg command.
You configure the transmission standard with the wlan mode command.
7.1.5.34

wlan data rate-11n defaults (Access Point)

Description
You can reset the selection to the default setting with this command.
Note
This command is available only in access point mode.
Requirement
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
● The transmission standard IEEE 802.11a/b/g/n is set.
● The "Use selected data rates only" function is enabled.
Syntax
Call the command without parameter assignment:
wlan data rate-11n defaults
Result
The selection is reset to the default setting.
Further notes
You display the setting with the show wlan data rates command.
You disable the function with the no wlan data rates-11n selected only command.
You configure the data transmission speeds with the wlan data rate-11n command.
You configure the transmission standard with the wlan mode command.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network structures
7.1 WLAN
239