Show Mac-Address-Table Dynamic Unicast - Siemens SCALANCE W770 Series Configuration Manuals

Simatic net industrial wireless lan ieee 802.11n command line interface

Table of Contents

show mac-address-table dynamic unicast

This command shows the MAC addresses of the dynamic unicast configuration.

● In "base bridge-mode", the mode for the device is set to "transparent".

You are in the User EXEC mode or in the Privileged EXEC mode.

The command prompt is as follows:

cli> or cli#

Call up the command with the following parameters:

show mac-address-table dynamic unicast[vlan<vlan-range>]

The parameters have the following meaning:

aa:aa:aa:aa:aa:

interface-type

interface-id

For information on names of addresses and interfaces, refer to the section "Interface identifiers

and addresses (Page 29)".

If you do not select any parameter from the parameter list, the entries are displayed for all

available interfaces.

The entries are displayed.

SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface

Configuration Manual, 09/2017, C79000-G8976-C324-08

[address<aa:aa:aa:aa:aa:aa>][{interface<interface-type>

<interface-id>}]

Keyword for a VLAN or VLAN range

Number of the addressed VLAN or VLAN range

Keyword for a MAC address

Keyword for a an interface description

Type or speed of the interface

Module no. and port no. of the interface

Network structures

Range of values / note

Enter a valid interface.

Show Quick Links

Table of Contents