No Wlan Ipcf-Ht Protocol-Support (Access Point); Wlan Ipcf-Ht Cycle-Time (Access Point) - Siemens SCALANCE W770 Series Configuration Manuals

5.5.2.4

no wlan ipcf-ht protocol-support (Access Point)

Note
This command is only available with the following KEY-PLUG:
● W780 iFeatures (MLFB 6GK5 907-8PA00)
Description
With this command, you disable the optimized support of PROFINET or Ethernet/IP.
Requirement
The SCALANCE W700 device is in access point mode
You are in the Interface Configuration mode of the WLAN interface.
The command prompt is as follows:
cli (config-if-wlan-0-X)#
Syntax
Call the command without parameters:
no wlan ipcf-ht protocol-support
Result
The optimized support of PROFINET or Ethernet/IP is disabled.
Further notes
You enable the optimized support of PROFINET or Ethernet/IP with the wlan ipcf-ht
protocol-support command.
You display the setting with the show wlan ipcf-ht command.
5.5.2.5

wlan ipcf-ht cycle-time (Access Point)

Note
This command is only available with the following KEY-PLUG:
● W780 iFeatures (MLFB 6GK5 907-8PA00)
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Functions specific to SCALANCE
5.5 iPCF-HT
135