Network Protocols; Ipv4 Protocol; The "Show" Commands; Show Dcp Forwarding - Siemens SCALANCE W770 Series Configuration Manuals

Network protocols

This part contains the sections that describe the commands for working with the various
network protocols.
8.1

IPv4 protocol

This section describes commands of the Internet Protocol (IP) version 4.
8.1.1

The "show" commands

This section describes commands with which you display various settings.
8.1.1.1

show dcp forwarding

Description
This command shows an overview of the DCP forwarding behavior on one or all interfaces.
Requirement
You are in the User EXEC mode or in the Privileged EXEC mode.
The command prompt is as follows:
cli> or cli#
Syntax
Call up the command with the following parameters:
show dcp forwarding [port<interface-type><interface-id>]
The parameters have the following meaning:
Parameter
port
interface-type
interface-id
For information on names of addresses and interfaces, refer to the section "Interface identifiers
and addresses (Page 29)".
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Description
Keyword for a an interface description
Type or speed of the interface
Module no. and port no. of the interface
Range of values / note
-
Enter a valid interface.
8
341