Commands In The Global Configuration Mode; Ip Http - Siemens SCALANCE W770 Series Configuration Manuals

Syntax
Call the command without parameters:
show ip http server status
Result
The status of the HTTP server is displayed.
8.8.2

Commands in the Global Configuration mode

This section describes commands that you can call up in the Global configuration mode.
In Privileged EXEC mode, enter the configure terminal command to change to this mode.
Commands relating to other topics that can be called in the Global configuration mode can be
found in the relevant sections.
You exit the Global configuration mode with the end or exit command and are then in the
Privileged EXEC mode again.
8.8.2.1

ip http

Description
With this command, you enable HTTP on the device.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call the command without parameters:
ip http
As default the function is "enabled".
Result
HTTP is enabled on the device.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Configuration Manual, 09/2017, C79000-G8976-C324-08
Network protocols
8.8 HTTP server
443