Network protocols
8.6 SNMP
8.6.2.13
no snmp group
Description
With this command, you delete the details of an SNMP group.
Requirement
You are in the Global configuration mode.
The command prompt is as follows:
cli(config)#
Syntax
Call up the command with the following parameters:
no snmp group <GroupName> user <UserName> security-model {v1|v2c|v3}
The parameters have the following meaning:
Parameter
GroupName
user
UserName
security-model
Result
The details of the group are deleted.
Further notes
You change the details of an SNMP group with the snmp group command.
You display the created SNMP groups with the show snmp group command.
You display the created SNMP users with the show snmp user command.
8.6.2.14
snmp notify
Description
With this command, you configure the details of the SNMP notifications.
424
Description
Name of the group
Keyword for the user name
Name of the user
Specifies which security settings are
used for sending.
SCALANCE W770/W730 acc. to IEEE 802.11n Command Line Interface
Range of values / note
max. 32 characters
-
max. 32 characters
● v1
● v2c
● v3
Configuration Manual, 09/2017, C79000-G8976-C324-08