1-9-13 Zero Execute/Cancel; 1-9-14 Software Reset - Omron K3HB-PPB Technical Communications User's Manual

Commands and Responses (CompoWay/F Communications)
Response

1-9-13 Zero Execute/Cancel

Command
Response

1-9-14 Software Reset

Command
Response
MRC SRC
Response code
"30" "05" "0000"
Response codes: The above indicates a normal end. For the response codes,
see 1-7 Operation Commands (CompoWay/F Communications) (page 1-11).
Command Related
MRC SRC
code information
"30" "05" "03"
Related information
"00" Zero cancel
"01" Zero execute
This command is used to execute/cancel the forced zero and tare zero func-
tions. The results of the command will depend on the status of the tare zero
setting, as shown below.
Tare Commands executed in order left to right.
zero
Zero execute
OFF Forced zero ON
ON Forced zero ON
This command can be used only in setting area 0. An operation error will
occur in the following situations.
• When there is no-measurement status, there is an input error, or a mea-
surement is outside the display range (but zero cancel is possible.)
• When a RESET or HOLD input is ON
• When the command is used in setting area 1
MRC SRC Response code
"30" "05" "0000"
Response codes: The above indicates a normal end. For the response codes,
see 1-7 Operation Commands (CompoWay/F Communications) (page 1-11).
Command Related
MRC SRC code information
"30" "05" "06" "00"
A software reset causes the same operation as turning the power off and on.
This command can be used in both setting area 0 and setting area 1.
To use this command, "Write via communications" must be enabled using the
"Write via communications" operation command.
(No response)
A response is not returned to this operation command.
Description
Zero execute Zero cancel
Forced zero ON Forced zero OFF Forced zero OFF
Tare zero ON Tare zero OFF
Section 1-9
Zero cancel
Forced zero OFF
1-19