Table of Contents
Advertisement
Field Replaceable Units
7.
Lower the new fan assembly into the chassis. Be sure to align the pins on the
bottom of the fan assemblies with the grommets on the chassis, and align the
fan assembly with the plastic fan assembly guide on the right inside wall of
the chassis. Press the fan assembly down to ensure the fan connector is in
place.
8.
Close the chassis front top cover and tighten the two screws on each side that
fasten the cover to the chassis.
9.
Depending on how the fan assembly was accessed in step 2, return the T1100
AS chassis to its original position using one of the following procedures:
• Procedure 7-3, "Slide T1100 AS Chassis Back into Frame," on page 7-11
• Procedure 7-5, "Return a T1100 AS Chassis to the Frame," on page 7-16
10.
If requested, return the failed fan assembly to Tekelec. Arrange the return
shipment by using the procedures in "How to Arrange Return Shipping" on
page B-19.
11.
This procedure is complete.
How to Replace the Square Fan Assembly
Perform the following procedures to replace the square fan assembly. This
procedure can be performed while the T1100 AS chassis remains powered.
SHOW ME: To view a video (with sound) that shows some steps of the
following procedure,
and data, be sure to read all the steps in the following procedure. For more
information about how to view this video, see "Programs Needed to View
Linked Documents" on page 1-4.
Procedure 7-8.
1.
Ensure that the following have been done:
a.
An RMA has been obtained (see Procedure B-1, "Obtaining an RMA," on
page B-2); for information about the part number to be supplied, see "Fan
Assembly Part Number Information" on page B-3.
b.
A spare part is available
910-2969-001 Revision H, February 2007
DRAFT
click
here. For personnel safety and to protect equipment
Replace a Square Fan Assembly
7-23
Advertisement
Table of Contents
