Table of Contents
Advertisement
Field Replaceable Units
17.
From the rear of the frame attach the cable to the PCI card.
18.
Do one of the following:
• If this procedure is being performed to replace a failed PCI card, skip to
the next step.
• If this procedure is being performed to move PCI cards from a failed T1100
AS chassis to the replacement T1100 AS chassis, repeat step 5 through
step 17 for each PCI card to be moved.
19.
Replace the top rear cover on the T1100 AS chassis. Slide the guide slots over
and past the screws loosened in step 8 on page 7-42.
20.
Tighten the four guide screws attaching the rear top cover to the T1100 AS
chassis.
21.
Tighten the captive fastener at the rear of the cover.
22.
Close the chassis rear top cover.
23.
Do one of the following:
• If this procedure is being performed to move PCI cards from a failed T1100
AS chassis to the replacement T1100 AS chassis, skip to the next step.
• If this procedure is being performed to replace a failed PCI card, do the
following:
— Attach the label that was received with the replacement PCI card on
— Return the failed PCI card to Tekelec, using the shipping contained in
24.
This procedure is complete.
910-2969-001 Revision H, February 2007
DRAFT
the appropriate section of the PCI card label located on the left side of
the T1100 AS chassis (for a diagram of the label, see Figure 7-20 on
page 7-41; for placement of this label on the T1100 AS chassis, see
Figure B-8 on page B-9).
which the replacement PCI card was received. Arrange the return
shipment by using the procedures described in Appendix B,
"Hardware Repair and Return."
7-45
Advertisement
Table of Contents
