Figure 5-3. Slide Assembly Inner Member Roller Side View - Tekelec 1100 Hardware Manual

Figure 5-3. Slide Assembly Inner Member Roller Side View

5.
Set the slide members aside for use later in this procedure.
6.
Attach the four frame adapter brackets to the frame (23-inch frame only)
using two each of the #12-24 Phillips screws. Orientation is important; see
Figure 5-4 and Figure 5-5 for views of the frame adapter brackets with correct
positioning. The small jog in the brackets is directed toward the rear of the
frame.
NOTE: If the frame is 19-inch, do not use the frame adapter brackets. In
19-inch frames, the slide assembly brackets that are attached to the outside
members are attached directly to the frame.
5-6
How to Install Hardware in an Existing Frame
Preliminary
Slide Release Button
910-2969-001 Revision H, February 2007