How To Anchor To Overhead Rack Of Hd Frame; Figure 4-9. Anchoring Frame Using Support Channel/Spring Nut - Tekelec 1100 Hardware Manual

Figure 4-9. Anchoring Frame Using Support Channel/Spring Nut

5 threads of the
threaded rod
must show above
the nut
Isolator pad
Raised floor
Concrete floor
04_raised_floor_spring-nut
4.
Insert the large washer, small washer, and torque nut onto the threaded rod
on the inside of the frame. Be sure to leave at least 5 threads of threaded rod
exposed on the inside of the frame. Tighten the nuts above the raised floor.
NOTE: DO NOT over tighten, causing the tile or frame to tilt.
5.
This procedure is complete.
Next, go to Procedure 4-8, "Attach Overhead Rack Support," on page 4-19.

How to Anchor to Overhead Rack of HD Frame

Frames with shelves that extend must be attached to overhead racks to prevent
toppling.
4-18
Preliminary
Frame
side
Finger tighten threaded rod
through channel nut
Support channel
(example Unistrut)
P/N 804-0870-01
910-2969-001 Revision H, February 2007
How to Install a T1100 AS Frame
Tighten nut on
Small washer
Large washer
Threaded
rod
Spring
Unistrut
Detail
Sping washer
channel nut
P/N 804-0913-01
Channel
nut