Figure B-5. T1100 As Chassis Front View - Tekelec 1100 Hardware Manual

Hardware Repair and Return
Procedure B-3. How to Locate serial numbers for Removable Media Disk
WARNING:
frame when working on electronic components.
1.
From the front of the frame, remove the # 12-24 Phillips screw from each
chassis retention bracket (see Figure B-1). Do not remove the screws in the
frame adapter brackets.

Figure B-5. T1100 AS Chassis Front View

2.
From the front of the frame, using the knurled screws on the sides of the
chassis, pull forward until the release buttons on the inner arms of the slide
assemblies pop into the holes on each side. Be careful to not disconnect, bind,
or pinch any cables.
DANGER: If the T1100 AS chassis is pulled too far out after the release
buttons are disengaged, the inner slide members (attached to the chassis)
could come out of the middle slide members (attached to the frame).
3.
Using a Phillips screwdriver, loosen screws on the T1100 AS chassis front top
cover until they are free. See Figure B-6 for locations.
910-2969-001 Revision H, February 2007
Preliminary
Drive Assembly
Always wear an ESD wrist strap grounded to the bench or
B-7