Figure 7-20. Pci Slots Label - Tekelec 1100 Hardware Manual

Field Replaceable Units

Figure 7-20. PCI Slots Label

WARNING: This procedure CANNOT be performed while the T1100 AS
chassis is powered on. Never power OFF a T1100 AS chassis until the
application software and platform operating system (OS) are shut down.
2.
Shut down the application and operating system. If possible, use the
procedures in the application manual for a "soft shutdown." If the application
interface is not operating or is not accessible, a hard shutdown (turning OFF
the breakers) is sometimes required. Contact the Customer Care Center before
doing a hard shutdown.
3.
Turn OFF the power switch on the chassis. Next, turn OFF the circuit breakers
that supply power to the T1100 AS chassis containing the PCI card to be
removed.
To locate the circuit breakers supplying power to the T1100 AS chassis, refer to
the system interconnect diagram for the system type and/or read the labels on
the breakers. To access the circuit breakers on some frames, it may be
necessary to remove the plastic covers on the front of the breakers. If the
covers are removed, to maintain NEBS compliance, make sure they are
replaced when the FRU replacement has been completed.
WARNING: A T1100 AS chassis is redundantly powered from both A and
B -48 VDC buses. Ensure that both the circuit breaker supplying A power to
a chassis and the circuit breaker supplying B power to a T1100 AS chassis
are turned OFF by measuring the voltage with a VOM on the cable that
connects the T1100 AS chassis to its breakers. Both A and B power LEDs on
the front fascia of the T1100 AS chassis should be OFF.
910-2969-001 Revision H, February 2007
DRAFT
– A label (see Figure 7-20) to attach to the PCI card label on the left
side of the T1100 AS chassis (see Figure B-8 on page B-9)
03_ts_pci_config_label
7-41