Table of Contents
Advertisement
Post Installation Procedures
Table 6-1.
Post-Installation Checklist (Continued)
Check
When
Done
Customer site survey book is signed off.
Check that power coming into the frame is -48V +/- 6V before powering up the
frame.
How to Power Up
WARNING: Only a certified Tekelec test engineer should power up a system
after installation.
To power up, set the appropriate breakers to the ON position as described in one
of the following sections.
• "How to Power Up a Heavy Duty Frame" on page 6-15
• "How to Power Up Added T1100 AS Unit in DC Environment" on page 6-15
• "How to Power Up a T1100 AS Unit in an AC Environment" on page 6-16
Turn the switch on the front of the T1100 AS to ON. When the breakers that
supply power to the T1100 AS unit are switched ON, and the chassis switch is
turned ON, the unit will execute a power up sequence which includes a Power On
Self Test (POST). For information about initializing the software that runs on
T1100 AS chassis, refer to the application manuals included with your
documentation.
How to Power Up a Heavy Duty Frame
In a Direct Current (DC) environment, to power up the equipment installed in the
heavy duty frame, turn ON (flip the switch toward the | indicator) all the
breakers that correspond to servers in the frame, as shown in BreakerSettings.pdf.
Next, turn ON the power switch on the front of the T1100 chassis.
How to Power Up Added T1100 AS Unit in DC Environment
WARNING: Before powering up a server that has been added to an existing
frame in a DC environment, verify that the breakers that correspond to the
position where the server has been added are set to the OFF (O) position. Then,
be sure that the chassis switch is set to the OFF position.
910-2969-001 Revision H, February 2007
Preliminary
Verify that:
6-15
Advertisement
Table of Contents
