Figure B-16. T1100 As Chassis Front View - Tekelec 1100 Hardware Manual

3.
Determine whether the base unit/hard disk label, PCI slots label, and
memory label on the sides of the T1100 AS chassis can be viewed from the
sides of the frame without moving the chassis:
• If all labels can be viewed, go to step 6 on page B-17.
• If one or more labels cannot be viewed, go to the next step.
WARNING:
frame when working on electronic components.
4.
From the front of the frame, remove the # 12-24 Phillips screw from each
chassis retention bracket (see Figure B-1). Do not remove the screws in the
frame adapter brackets.

Figure B-16. T1100 AS Chassis Front View

5.
From the front of the frame, using the knurled screws on the sides of the
chassis, pull forward until the release buttons on the inner arms of the slide
assemblies pop into the holes on each side.
DANGER: If the T1100 AS chassis is pulled too far out after the release
buttons are disengaged, the inner slide members (attached to the chassis)
could come out of the middle slide members (attached to the frame).
B-16
Preliminary
Always wear an ESD wrist strap grounded to the bench or
Hardware Repair and Return
910-2969-001 Revision H, February 2007