How To Slide T1100 As Chassis Back Into Frame - Tekelec 1100 Hardware Manual

Field Replaceable Units
DANGER: If the T1100 AS chassis is pulled too far out after the release
buttons are disengaged, the inner slide members (attached to the chassis)
could come out of the middle slide members (attached to the frame).
3.
This procedure is complete.
Next, replace the desired FRU using one of the following procedures:
• Procedure 7-8, "Replace a Square Fan Assembly," on page 7-23
• Procedure 7-9, "Replace a Hard Disk Drive Assembly," on page 7-26
• Procedure 7-10, "Replace a Removable Media Disk Drive Assembly," on page
7-32
• "Replace a power supply module" on page 7-38
• Procedure 7-12, "Replace a PCI Card," on page 7-40
When the desired FRU has been replaced, perform Procedure 7-3, "Slide T1100 AS
Chassis Back into Frame," on page 7-11.

How to Slide T1100 AS Chassis Back into Frame

Perform the procedure in this section to slide the T1100 AS chassis back into the
frame if one of the following FRUs was accessed by sliding the T1100 AS chassis
out of the frame:
• Fan assemblies
• Fan filters
• Hard disk drive assemblies
• Removable media disk drive assemblies
• PCI cards
Procedure 7-3.
WARNING:
when working on electronic components.
1.
From the front of the frame, simultaneously press the round release buttons
and slowly push the chassis into the frame while observing the cables to avoid
binding or stretching.
NOTE: When the chassis stops moving, the front of the T1100 AS should
be slightly recessed to allow clearance behind the frame door when closed.
910-2969-001 Revision H, February 2007
DRAFT
Slide T1100 AS Chassis Back into Frame
Always wear an ESD wrist strap grounded to the bench or frame
7-11