T1100 As Chassis Part Number Information - Tekelec 1100 Hardware Manual

5.
From the front of the frame, using the knurled screws on the sides of the
chassis, pull forward until the release buttons on the inner arms of the slide
assemblies pop into the holes on each side. Be careful you do not disconnect,
bind, or pinch any cables.
DANGER: If the T1100 AS chassis is pulled too far out after the release
buttons are disengaged, the inner slide members (attached to the chassis)
could come out of the middle slide members (attached to the frame).
6.
Report the requested part number information from the PCI slots label.
7.
From the front of the frame, simultaneously press the round release buttons
and slowly push the chassis into the frame while observing the cables to avoid
binding or stretching.
NOTE: When the chassis stops moving, the front of the T1100 AS should
be slightly recessed to allow clearance of the handles behind the frame door
when closed.
8.
Adjust the chassis retention brackets on the front of the T1100 AS chassis to
contact the frame adapter brackets when the chassis is positioned correctly in
the frame.
9.
Secure the chassis with one # 12-24 screw in the chassis retention brackets on
each side.
10.
This procedure is complete.

T1100 AS Chassis Part Number Information

When a T1100 AS chassis needs to be replaced, part number information from all
of the following labels needs to be supplied:
• Frame identification from a label on the frame
• Server identification from a label on the front of the T1100 AS chassis
• Base unit and hard disk information from the base unit/hard disk label on the
left side of the T1100 AS chassis
• Memory information from a label on the right side of the T1100 AS chassis
• PCI card information from a label on the left side of the T1100 AS chassis
Use the following procedure to locate the necessary part information:
B-14
Preliminary
910-2969-001 Revision H, February 2007
Hardware Repair and Return