Figure 7-7. Inside View Of T1100 Showing Square Fan Assembly - Tekelec 1100 Hardware Manual

Field Replaceable Units

Figure 7-7. Inside view of T1100 showing square fan assembly

4.
With the thumb and forefinger of each hand, grasp the pins at the upper left
corner and lower right corner of the square fan assembly. Then, while still
holding the pins, pull the square fan assembly out of the chassis.
5.
Insert the new square fan assembly. Be sure to align the pins on the bottom of
the assembly with the grommets in the chassis. Push the fan assembly in until
it is flush with the front edge of the chassis.
6.
Swing the front fascia up and lock it. Tighten the knurled screws on either side
of the front fascia. Check to ensure the CD/DVD drive can still eject.
7.
Close the chassis front top cover and tighten the two screws on each side that
fasten the cover to the chassis.
8.
Depending on how the fan assembly was accessed in step 2, return the T1100
AS chassis to its original position using one of the following procedures:
• Procedure 7-3, "Slide T1100 AS Chassis Back into Frame," on page 7-11
• Procedure 7-5, "Return a T1100 AS Chassis to the Frame," on page 7-16
910-2969-001 Revision H, February 2007
DRAFT
7-25