How to Install Hardware in an Existing Frame
5.
Remove the slide assemblies from the shipping container. The slide assemblies
(see Figure 5-1) consist of three sections that will be attached to the T1100 AS
chassis and frame.
Figure 5-1. Slide Assembly
Detent Latch
6.
Inspect the slide assemblies for indication of damage. If damage is noted, go
to step 7.
7.
If any damage is noted or parts are missing, contact the Customer Care Center
(see "Customer Assistance" on page 1-7).
910-2969-001 Revision H, February 2007
Preliminary
Middle Slide Member
Outer Slide Member
Inner Slide Member
Release Button
Located on other side
5-3