How To Install An Individual T1100 As Unit - Tekelec 1100 Hardware Manual

How to Install an Individual T1100 AS Unit

Use the following procedure to install an individual T1100 AS unit into an
existing frame. (For more information about the situations in which an individual
T1100 AS unit can be installed, see "Introduction" on page 5-2.)
Tools Required:
• #3 Phillips screwdriver
• 3/8 inch nutdriver
• Volt Ohm Meter (VOM)
Procedure 5-2.
TOPPLE: Before beginning this procedure, ensure the frame is properly
secured to the floor and cable racks to prevent the frame from tipping over
when the slide assembly and T1100 AS chassis is extended.
topple
DANGER: Moving a T1100 AS chassis requires two people. Each T1100 AS
chassis weighs approximately 30 kg (65 lbs) and may cause personnel injury or
damage to the internal components due to shock and vibration if not handled
properly.
1.
Turn OFF the breakers that supply power to the position the T1100 AS chassis
is being installed in. Consult the system interconnect or wiring tables for the
frame or system type the T1100 AS chassis is installed in.
WARNING: A T1100 AS chassis is redundantly powered from both A and
B -48 VDC buses. Ensure that both the circuit breaker supplying A power to
a chassis and the circuit breaker supplying B power to a T1100 AS chassis
are turned OFF by measuring the voltage with a VOM on the cable that
connects the T1100 AS chassis to its breakers. Both A and B power LEDs on
the front fascia of the T1100 AS chassis should be OFF.
2.
Remove the front door and any plastic panels from the rear of the frame
where the T1100 AS chassis is to be installed. Using an erasable marker
indicate the location of the mounting screw holes on the frame rails reserved
for the frame brackets. T1100 AS chassis are mounted to slide assemblies
attached to the frame brackets for ease of installation and servicing.
5-4
Preliminary
Installing a T1100 AS Chassis
How to Install Hardware in an Existing Frame
910-2969-001 Revision H, February 2007