Table of Contents
Advertisement
Field Replaceable Units
Figure 7-17. CD/DVD chassis screws
13.
Place the CD/DVD drive assembly in an ESD container. If requested return
the drive to Tekelec using the procedures described in Appendix B,
"Hardware Repair and Return."
14.
Insert the new CD/DVD drive assembly. Attach the data and power cables on
the back of the removable media disk drives. See Figure 7-15.
NOTE: The location of the top cable was marked in step 10 on page 7-35.
15.
Tighten the CD/DVD drive chassis screws on the left side of the chassis.
16.
Tighten the CD/DVD bracket screw on the right side of the drive assembly.
17.
Close the chassis top rear cover and tighten the knurled screw at the rear of
the chassis.
18.
Close the front top cover and tighten the screws to secure the top cover.
19.
Swing the front fascia closed, lock the front fascia, and tighten the knurled
screws on the sides of the chassis to secure the front fascia. Be sure the
CD/DVD drive can eject.
910-2969-001 Revision H, February 2007
DRAFT
7-37
Advertisement
Table of Contents
