Table of Contents
Advertisement
4.
Prepare the T1100 AS chassis for access to the FRU using one of the following
procedures:
WARNING:
frame when working on electronic components.
• Procedure 7-2, "Slide T1100 AS Chassis Out from Frame," on page 7-10
• Procedure 7-4, "Remove a T1100 AS Chassis from Frame," on page 7-12
NOTE: If this procedure is being performed to move PCI cards from a
failed T1100 AS chassis to a replacement T1100 AS chassis, Procedure 7-4,
"Remove a T1100 AS Chassis from Frame," on page 7-12 is recommended.
5.
Determine the slot location of the PCI card to be removed using the T1100 AS
PCI slots label located on the left rear of the of the chassis. See Figure 7-21 on
page 7-43.
NOTE: Each T1100 AS chassis has a unique PCI configuration label
listing card types and slot arrangements.
6.
Ensure that all cables are labeled. Label any that are not labeled.
7.
From the rear of the frame remove any cables attached to the PCI card to be
removed.
8.
From the rear of the chassis remove the rear top cover.
a.
First loosen the four screws in the guide slots on both sides of the rear top
cover.
b.
Unscrew the captive fastener at the rear of the rear top cover until it
releases.
c.
Pull the cover toward the rear until the screws are clear of the guide slots
then lift up. See Figure 7-21.
7-42
Preliminary
Always wear an ESD wrist strap grounded to the bench or
Field Replaceable Units
910-2969-001 Revision H, February 2007
Advertisement
Table of Contents
