Figure 4-8. Anchor Assembly For Support Channel With Spring Nut - Tekelec 1100 Hardware Manual

How to Install a T1100 AS Frame

Figure 4-8. Anchor Assembly for Support Channel with Spring Nut

Note: When an anchor assembly is used on a raised floor, the anchor
assembly must be disassembled and the correct length of threaded rod of the
proper diameter must be used for the floor height requirement. Finger tighten
any nuts above raised floor before tightening nuts below raised floor
Large washer
Fiber washer
Nylon shoulder
washer
Threaded rod
(see note)
3.
Finger tighten the rods into the spring nut in the support channels (see
Figure 4-9).
910-2969-001 Revision H, February 2007
Preliminary
Anchor
Raised Floor
Small steel
washer
Support channel
(example Unistrut)
Torque nut
(red plastic cover)
Frame floor
Isolator pad
Raised floor
Raised floor
Concrete floor
Spring nut
Frame floor
04_anchor_rsdflr_no_cone
4-17