Figure 7-15. Removable Media Disk Drive Cables (Drives Removed) - Tekelec 1100 Hardware Manual

Field Replaceable Units
6.
Grasp the edge of the front top cover of the chassis and lift up to remove the
cover.
7.
To access the IDE cables of the drives, remove the top rear cover. Unscrew the
knurled screw at the back of the chassis. Slide the cover towards the rear of the
chassis and lift the cover off of the chassis.
8.
You must remove both rectangular fans to access the CD/DVD drive bracket
screw. There are two rectangular fan assemblies on the right of the chassis. The
removal instructions are the same for each assembly. Grasp the top of each fan
assembly with your index finger underneath the left and right edges of the top
of the fan assembly. Lift the fan assembly straight up and out of the chassis to
remove it.
9.
Set the rectangular fan assemblies aside.
10.
Unplug the two flat 40-position IDE data cables and the single power cable
from the drive adapter board. With a permanent marker, mark the IDE cable
that is attached to the top IDE connector on the board.

Figure 7-15. Removable Media Disk Drive Cables (drives removed)

910-2969-001 Revision H, February 2007
DRAFT
7-35