Figure 7-9. Hard Drive Removal - Tekelec 1100 Hardware Manual

Field Replaceable Units
6.
Insert your index finger into the right side of the drive release latch. Pull the
latch towards you to disengage the drive and pull the drive out of the chassis.

Figure 7-9. Hard drive removal

7.
Remove the hard disk drive and store in an approved ESD package or place
on a grounded bench.
8.
Do one of the following:
• If this procedure is being performed to replace a failed hard disk drive,
note the position label attached to the failed hard disk drive assembly.
Select the matching label ("A" or "B") from the contents of the shipping
container in which the replacement hard disk drive assembly was
received, and apply it to the hard disk drive. Figure 7-12 shows where the
labels should be applied
• If this procedure is being performed to move hard disk drive assemblies
from a failed T1100 AS chassis to the replacement T1100 AS chassis, locate
the part numbers on each of the hard disk drive assemblies (see Figure
7-12).
Ensure that the part numbers on hard disk drive assemblies to be moved
match the part numbers for both the A and B positions on the base
unit/hard disk label on the front of the left side of the replacement T1100
AS chassis (see Figure 7-10 and Figure 7-11). If the part numbers do not
match, contact the Customer Care Center.
910-2969-001 Revision H, February 2007
DRAFT
7-29