Table of Contents
Advertisement
Field Replaceable Units
CAUTION: This procedure to replace the hard drives can be performed
while the T1100 AS is powered on. However, do not remove both hard
drives simultaneously.
2.
Check the LEDs on the front fascia for an indication of which drive needs to be
replaced. Refer to the application manual to perform any procedures
recommended to limit data loss or corruption. For example, the application
manual may require:
• Prepare the failed drive for replacement
• Data mirroring before replacing a failed hard disk drive
• Application shutdown before powering off a T1100 AS chassis
3.
Prepare the T1100 AS chassis for access to the FRU using one of the following
procedures:
WARNING:
frame when working on electronic components.
• Procedure 7-2, "Slide T1100 AS Chassis Out from Frame," on page 7-10
• Procedure 7-4, "Remove a T1100 AS Chassis from Frame," on page 7-12
NOTE: If this procedure is being performed to move hard disk drives
from a failed T1100 AS chassis to a replacement T1100 AS chassis,
Procedure 7-4, "Remove a T1100 AS Chassis from Frame," on page 7-12 is
recommended.
4.
To replace the hard drives, first open the front fascia by unscrewing the
knurled screws on either side of the chassis, and use the key to unlock the
front fascia. Once unlocked, carefully swing the front fascia open from the top
of the chassis. The two hard drives are located below the rectangular fans. See
Figure 7-8 for hard drive locations.
CAUTION: Be sure you do not unplug the cable from the printed circuit
board behind the front fascia while opening the front fascia. Removing this
cable from its connections will cause the server to shut down.
910-2969-001 Revision H, February 2007
DRAFT
Always wear an ESD wrist strap grounded to the bench or
7-27
Advertisement
Table of Contents
