Tekelec 1100 Hardware Manual page 129

Field Replaceable Units
WARNING: When replacing both drives in a failed T1100 AS chassis
always place the drives in the locations they were removed from. Failure to
replace the drives in the correct locations will cause data corruption and
render the unit inoperable.
9.
Insert the new drive. As the drive engages the connectors push the latch
closed to lock the drive in position.
10.
Do one of the following:
• If this procedure is being performed to replace a failed hard disk drive,
skip to the next step.
• If this procedure is being performed to move hard disk drive assemblies
from a failed T1100 AS chassis to the replacement T1100 AS chassis, repeat
step 5 through step 9 to move the other drive.
11.
Close the front fascia.
12.
Lock the front fascia and tighten the captive screws to secure the front fascia.
13.
Do one of the following:
• If this procedure is being performed to move hard disk drive assemblies
from a failed T1100 AS chassis to the replacement T1100 AS chassis, skip to
the next step.
• If this procedure is being performed to replace a failed hard disk drive, do
the following:
— Attach the label that was received with the replacement hard disk
— Return the failed hard disk drive assembly to Tekelec, using the
14.
Depending on how the hard disk drive assembly was accessed in step 3,
return the T1100 AS chassis to its original position using one of the following
procedures:
• Procedure 7-3, "Slide T1100 AS Chassis Back into Frame," on page 7-11
• Procedure 7-5, "Return a T1100 AS Chassis to the Frame," on page 7-16
910-2969-001 Revision H, February 2007
DRAFT
drive assembly on the base unit/hard disk label located on the front of
the left side of the T1100 AS chassis (for label placement, see
Figure 7-10 on page 7-30).
shipping contained in which the replacement hard disk drive
assembly was received. Arrange the return shipment by using the
procedures described in "How to Arrange Return Shipping" on
page B-19.
7-31