Table of Contents
Advertisement
Hardware Manual
5. Remove the slide assemblies from the shipping container.
The slide assemblies (see
will be attached to the T1100 AS chassis and frame.
Figure 44: Slide Assembly
6. Inspect the slide assemblies for indication of damage.
If damage is noted, go to
7. If any damage is noted or parts are missing, contact the
How to Install an Individual T1100 AS Unit
Use the following procedure to install an individual T1100 AS unit into an existing frame. (For
more information about the situations in which an individual T1100 AS unit can be installed, see
Introduction
on page 70.
Tools Required:
#3 Phillips screwdriver
3/8 inch nutdriver
Volt Ohm Meter (VOM)
1. Turn OFF the breakers that supply power to the position the T1100AS chassis is being installed
in.
910-2969-001 Revision K, June 2009
How to Install Hardware in an Existing Frame
Figure 44: Slide Assembly
Step 7
on page 71.
on page 71) consist of three sections that
Customer Care Center
on page 7.
71
Advertisement
Table of Contents
