Table of Contents
Advertisement
Hardware Manual
Next, go to
How to Anchor to Overhead Rack of HD Frame
How to Anchor on Raised Floor Using Support Channel with Spring Nut
Use the following procedure to an chor the HD frame to the raised floor tiles using the a support
channel with spring nut.
1. Ensure that
Additional Preparations for Raised Floors
2. Insert threaded rods through the frame and the raised floor and into the spring nut in the
support channel as shown in
page 65.
Figure 41: Anchor Assembly for Support Channel with Spring Nut
3. Finger tighten the rods into the spring nut in the support channels (see
Frame Using Support Channel/Spring Nut
Figure 42: Anchoring Frame Using Support Channel/Spring Nut
910-2969-001 Revision K, June 2009
on page 56 has already been performed.
Figure 41: Anchor Assembly for Support Channel with Spring Nut
on page 65).
How to Install aT1100 AS Frame
on page 66.
Figure 42: Anchoring
on
65
Advertisement
Table of Contents
