Figure 78: Removable Media Disk Drive Cables (Drives Removed) - Tekelec 1100 Hardware Manual

Application server
Hide thumbs Also See for 1100:
Table of Contents

Advertisement

Hardware Manual
12. Unplug the two flat 40-position IDE data cables and the single power cable from the drive
.assembly.
With a permanent marker, mark the IDE cable that is attached to the top IDE connector on the
board.drive assembly.

Figure 78: Removable Media Disk Drive Cables (drives removed)

Note: T1100 AS removable media drives and adapter are considered one FRU. Remove and
replace the entire adapter assembly including both removable media drives.
13. Place the CD/DVD drive assembly in an ESD container.
If requested return the drive to Tekelec using the procedures described in
Shipping Instructions
14. Insert the new CD/DVD drive assembly.
Attach the data and power cables on the back of the removable media disk drives. See
78: Removable Media Disk Drive Cables (drives removed)
Note: The location of the top cable was marked in
15. Tighten the CD/DVD drive chassis screws on the left side of the chassis.
16. Tighten the CD/DVD bracket screw on the right side of the drive assembly.
17. Re-install the rectangular fan assemblies.
18. Close the chassis top rear cover and tighten the knurled screw at the rear of the chassis.
19. Close the front top cover and tighten the screws to secure the top cover.
910-2969-001 Revision K, June 2009
on page 12
Field Replaceable Units
on page 127.
Step 12
on page 127.
Repair and Return
Figure
127

Advertisement

Table of Contents
loading

Table of Contents