How To Slide T1100 As Chassis Back Into Frame - Tekelec 1100 Hardware Manual

Hardware Manual
2. From the front of the frame, using the handles (T1000) or the knurled screws on the side of the
chassis (T1100), pull forward until the release buttons on the inner arms of the slide assemblies
pop into the holes on each side. While gently sliding the chassis, observe the cables to avoid
binding, stretching, or disconnecting.
DANGER: If the T1100 AS chassis is pulled too far out after the release buttons
are disengaged, the inner slide members (attached to the chassis) could come out
of the middle slide members (attached to the frame).
3. This procedure is complete.
Next, replace the desired FRU using one of the following procedures:
How to Replace the Square Fan Assembly
How to Replace Hard Disk Drive Assemblies
How to Replace Removable Media Disk Drives (CD/DVD)
How to Replace a Power Supply Module
How to Replace PCI Cards
When the desired FRU has been replaced, perform
on page 107.

How to Slide T1100 AS Chassis Back into Frame

Perform the procedure in this section to slide the T1100 AS chassis back into the frame if one of
the following FRUs was accessed by sliding the T1100 AS chassis out of the frame:
Fan assemblies
Fan filters
Hard disk drive assemblies
Removable media disk drive assemblies
910-2969-001 Revision K, June 2009
on page 116
on page 118
on page 128
on page 129
How to Slide T1100 AS Chassis Back into Frame
Field Replaceable Units
on page 123
107