DLDP configuration task list
For DLDP to work correctly, enable DLDP on both sides and make sure these settings are consistent:
the interval to send Advertisement packets, DLDP authentication mode, and password.
DLDP does not process any Link Aggregation Control Protocol (LACP) events. The links in an
aggregation are treated as individual links in DLDP.
Make sure that the DLDP version running on devices on the two ends are the same.
Complete the following tasks to configure DLDP:
Task
Configuring the duplex mode and speed of an Ethernet interface
Enabling DLDP
Setting DLDP mode
Setting the interval to send advertisement packets
Setting the DelayDown timer
Setting the port shutdown mode
Configuring DLDP authentication
Resetting DLDP state
Configuring the duplex mode and speed of an
Ethernet interface
To make sure DLDP works correctly on a link, you must configure the full duplex mode for the ports at
two ends of the link, and configure a speed for the two ports, rather than letting them negotiate a
speed.
To configure the duplex mode and speed of an Ethernet interface:
Step
1.
Enter system view.
2.
Enter Ethernet interface
view.
3.
Set the duplex mode.
4.
Set the port speed.
Command
system-view
interface interface-type
interface-number
duplex full
speed { 10 | 100 | 1000 |
10000 }
38
Remarks
Required
Required
Optional
Optional
Optional
Optional
Optional
Optional
Remarks
N/A
N/A
Optional.
By default, the duplex mode is auto for
Ethernet interfaces.
For more information about command, see
Interface Command Reference.
Optional.
By default, the port speed is automatically
negotiated.
For more information about the command,
see Interface Command Reference.