Editing/Generating Sensor Calibration Tables - Keysight N1913 User Manual

Editing/Generating Sensor Calibration Tables

Predefined sensor calibration factor table stored in power meter is not
NOTE
applicable for Keysight N8480 Series power sensors with Option CFT. Therefore,
users are required to create a new sensor calibration table for the sensors when
a sensor calibration table is needed.
To help achieve the best accuracy in your measurement you can enter the values
supplied for the sensors you are using by editing the installed sensor calibration
tables or by generating your own custom tables.
You cannot delete any of the 20 existing calibration tables or create any additional
tables. However, you can edit or delete the content of each table. If you need
another table you should edit and rename one of the tables. Each calibration table
can contain a maximum of 80 frequency points.
To view the calibration tables currently stored in the power meter, press
Tables
Figure
Table 6-3
Table
0
1
2
3
4
[a] DEFAULT is a sensor calibration table where the reference calibration factor and calibration factors are 100%. This sensor calibration table
can be used during the performance testing of the power meter.
[b] The 8482B and 8482H power sensors use the same data as the 8482A.
Keysight N1913/1914A User's Guide
,
Sensor Cal Tables
6-8.
Installed power sensor models
Sensor Model
[a]
DEFAULT
8481A
[b]
8482A
8483A
8481D
Using N8480 Series Power Sensors
. The Sensor Tbls screen is displayed as shown in
Table
5
6
7
8
9
Sensor Model
8485A
R8486A
Q8486A
R8486D
8487A
6
,
191