Calibrating; Figure 8-6 Calibration Type - Keysight N1913 User Manual

Calibrating

The N1913/1914A EPM Series power meters are able to perform calibration for
the U8480 USB thermocouple sensor via the front panel and SCPI. The N1913/
1914A EPM Series power meters also support auto calibration (Auto Cal) for the
U8480 USB thermocouple sensor. Both internal (Int) and external (Ext) calibration
is supported by the N1913/1914A EPM Series power meters.
Figure 8-6
The Auto Cal state is determined by the state of the calibration type as shown in
Figure
On and Off under the Auto Cal state. If the calibration type is set to Ext, the Auto
Cal state will be set to Off and the softkey will be greyed out.
When calibration is performed via the front panel or SCPI, the following message
will appear:
Keysight N1913/1914A User's Guide
Calibration type
8-6. If the calibration type is set to Int, you will be able to toggle between
Using U8480 Series USB Thermocouple Sensors 8
215