8480 Series Sensors Connection Requirements - Keysight N1913 User Manual

8480 Series Sensors Connection Requirements

Table 5-1 8480 Series connection requirements
Sensor
8481A
8481H
8482A
8482H
8481D
8484A
8483A
R8486A
Q8486A
V8486A
W8486A
E8486A
R8486D
Q8486D
8481B
8482B
8485A
8485D
8487A
8487D
Keysight N1913/1914A User's Guide
Connection Requirements
These power sensors connect directly to the POWER REF.
Prior to calibration, a Keysight 11708A 30 dB reference attenuator should be connected
between the power sensor and the POWER REF. Remove this attenuator from the power
sensor input before making measurements.
This power sensor requires a 75 Ω (f) to 50 Ω (m) N-Type adapter (1250-0597) to connect
to the POWER REF. Remove this adapter before making measurements.
These waveguide power sensors have two connectors. Use the N-Type connector to
calibrate the power meter.
These power sensors are configured with an attenuator. Prior to calibration this attenuator
must be removed. Replace the attenuator before making measurements.
This power sensor requires an APC 3.5 (f) to 50 Ω (m) N-Type adapter (08485-60005) to
connect to the POWER REF. Remove this adapter before making measurements.
Prior to calibration, a Keysight 11708A 30 dB reference attenuator and an APC 3.5 (f) to
50 Ω (m) N-Type adapter (08485-60005) should be connected between the power sensor
and the POWER REF. Remove this attenuator and adaptor before making measurements.
This sensor requires an APC 2.4 (f) to 50 Ω (m) N-Type adapter (08487-60001) to connect
to the POWER REF. Remove this adapter before making measurements.
Prior to calibration, a Keysight 11708A 30 dB reference attenuator and an APC 2.4 (f) to
50 Ω (m) N-Type adapter (08487-60001) should be connected between the power sensor
and the POWER REF. Remove this adapter before making measurements.
Using 8480 Series Power Sensors 5
157