Keysight N1913 User Manual page 227

–
Too many digits
124
A numeric parameter was found whose mantissa contained more than 255 digits, excluding leading zeros.
–
Numeric data not allowed
128
A numeric value was received within a command which does not accept a numeric value.
For example, MEM:CLE 24.
–
Invalid suffix
131
A suffix was incorrectly specified for a numeric parameter. You may have misspelled the suffix.
For example, SENS:FREQ 200KZ.
–
Suffix too long
134
A suffix used contained more than 12 characters.
For example, SENS:FREQ 2MHZZZZZZZZZZZ.
– Suffix not allowed
138
A suffix was received following a numeric parameter which does not accept a suffix.
For example, INIT:CONT 0Hz.
– Character data not allowed
148
A discrete parameter was received but a character string or a numeric parameter was expected. Check the
list of parameters to verify that you have used a valid parameter type.
For example, MEM:CLE CUSTOM_1.
– Invalid string data
151
An invalid string was received. Check to see if you have enclosed the character string in single or double
quotes.
For example, MEM:CLE "CUSTOM_1.
– String data not allowed
158
A character string was received but is not allowed for the command. Check the list of parameters to verify
that you have used a valid parameter type.
For example, LIM:STAT 'ON'.
– Invalid block data
161
A block data element was expected but was invalid for some reason.
For example, *DDT #15FET. The 5 in the string indicates that 5 characters should follow, whereas in this
example there are only 3.
–
Block data not allowed
168
A legal block data element was encountered but not allowed by the power meter at this point.
For example, SYST:LANG #15FETC?.
–
Expression data not allowed
178
A legal expression data was encountered but not allowed by the power meter at this point.
For example, SYST:LANG (5+2).
Keysight N1913/1914A User's Guide
Maintenance 9
227