Table of Contents
Advertisement
6
Using N8480 Series Power Sensors
There are also ten sensor calibration tables named CUSTOM_0 through
CUSTOM_9. These tables do not contain any data when the power meter is
shipped from the factory.
Editing frequency dependent offset tables requires the following steps:
1 Identify and select the table you want to edit
2 Rename the table
3 Enter the frequency and offset pairs
4 Save the table
Procedure
First, select the table you want to edit as follows:
1 Press
Figure 6-11
2 Choose the table you want to edit using the
192
,
Tables
"Sensor Tbls" screen
to display the Ed it Cal screen as shown in
Ed it Table
,
Sensor Cal Tables
Keysight N1913/1914A User's Guide
to display the Sensor Tbls screen.
and
keys. Press
Figure
6-12.
Advertisement
Table of Contents
