Figure 2-12 Changing Offset Unit - Keysight N1913 User Manual

2 General Power Meter Functions
The following rules apply to naming sensor calibration tables:
NOTE
– The name must consist of no more than 12 characters.
– All characters must be upper or lower case alphabetic characters, or numeric
– No other characters are allowed.
– No spaces are allowed in the name.
Enter (or edit) the frequency and offset pairs as follows:
1 Press
2 Enter the new offset value (or press
Figure 2-12
3 Continue adding/editing values until you have entered all the data you require.
4 When you have finished editing the table press
70
(0-9), or an underscore (_).
to add a new frequency value (or press
Insert
numeric keypad to enter the required value in the Frequency pop-up window.
Complete the entry by pressing the
to enter the required value in the Offset pop-up window. Complete the entry by
pressing the key.
%
Changing offset unit
Change
, keys.
GHz MHz
to edit). Use the numeric keypad
Change
to save the table.
Done
Keysight N1913/1914A User's Guide
to edit). Use the