Error Message List - Keysight N1913 User Manual

9 Maintenance

Error Message List

– Invalid character
101
An invalid character was found in the command string. You may have inserted a character such as #, $, or %
in the command header or within a parameter.
For example, LIM:LOW O#.
– Syntax error
102
Invalid syntax was found in the command string.
For example, LIM:CLE:AUTO, 1 or LIM:CLE: AUTO 1.
–
Invalid separator
103
An invalid separator was found in the command string. You may have used a comma instead of a colon,
semicolon, or blank space; or you may have used a blank space instead of a comma.
For example, OUTP:ROSC,1.
-105 GET not allowed
A Group Execute Trigger (GET) is not allowed within a command string.
–
Parameter not allowed
108
More parameters were received than expected for the command. You may have entered an extra parameter,
or added a parameter to a command that does not accept a parameter.
For example, CAL 10.
–
Missing parameter
109
Fewer parameters were received than expected for the command. You omitted one or more parameters that
are required for this command. For example, AVER:COUN.
– Program mnemonic too long
112
A command header was received which contained more than the maximum 12 characters allowed.
For example, SENSeAVERageCOUNt 8.
– Undefined header
113
A command was received that is not valid for this power meter. You may have misspelled the command, it
may not be a valid command or you may have the wrong interface selected. If you are using the short form
of the command, remember that it may contain up to four letters.
For example, TRIG:SOUR IMM.
– Invalid character in number
121
An invalid character was found in the number specified for a parameter value.
For example, SENS:AVER:COUN 128#H.
– Exponent too large
123
A numeric parameter was found whose exponent was larger than 32,000.
For example, SENS:COUN 1E34000.
226 Keysight N1913/1914A User's Guide